Anti-rolling tires to experience the whole process of technology

At present, the passenger car tire almost all can do the anti prick treatment, the principle of this technique is to use the automatic NC spraying equipment MPN glue evenly coated on the inner wall of the tire, tire forming protective coating a layer of 3-5mm, when the diameter below 6mm in sharp objects piercing tire quickly when be MPN compound coating wrapped tightly without leakage; when the sharp objects are pulled out, perforation is MPN rubber coating instantly filled and sealed, effectively solve the vacuum tire stabbed rolling or discouraged trachoma caused and slow leakage phenomenon; similarly, MPN rubber coating can withstand the tread 10cm long wound without leakage. With every car 4 tires, a tire puncture preventing processing time required for 1.5-2 hours.

Give you about MPN glue, MPN glue is a semi-solid gel resin, high toughness, high polymerization degree, high peel strength, memory and self repairing characteristics, softening point temperature is 110 ℃, cold bending crack free, at -40 ℃ -110 ℃ temperature range can be maintained the performance of the same.

This experiment is very simple, we use the test vehicle for the anti prick treatment tire, directly on the test board and two blocks over, the two pieces of test board is a piece of 5 nails installed, and the other is a triangle plate installed, the two things in our daily the road on the way to the tire is a great threat.

Manufacturers technology full of confidence, said test can be reached 60km/h in the vehicle speed, but the site and the test board is too small, if the speed is too fast will roll up the test board to fly, not very safe, so we have to vehicle idling in the D block to pressure test board. After finished the test 1, test 2 and test completed in 1 hours, we have measured the tested tire pressure, and tire pressure does not have any change, are kept in the 2.85bar (do not represent the actual standard of car tire pressure).

Tire after the upgrade, four tire weight increase of about 6-8kg, fuel consumption is increased, but the show was not obvious, for many large cars, 6-8kg weight is negligible. We do the anti prick treatment is for the purpose of security, to increase the unsprung mass brings in performance or fuel consumption factors, in the car will not be reflected very direct.

Tire during the upgrade, MPN glue evenly coated on the inner wall of tire high speed rotation, the tire wall mirror like smooth, so after the upgrade of the auto balance and upgrade without much difference. MPN glue is semi solid rubber tire and tire, sprayed on the inner wall is very fit, does not affect the ehardness of the tire, in the running process can absorb the tire contact with the ground and produce vibration and noise, so after the upgrade the car noise can be reduced, the ride comfort can be improved.

More useful car tools like Launch X431 IV andGM Tech 2 can help you do better on cars.